Electrical Connection

GBD_GBDF SERIES GAS FRYERS

When installing a quick disconnect you must also install a means for limiting the movement of the fryer. This device will prevent the gas line or quick disconnect from being strained. The restraining device should be attached to the cutout on the back panel. See illustration for location.

In Australia, use only the caster supplied by the manufacturer for the fryer device. The fryer must be installed using a hose assembly restraining device to limit the movement of the appliance in accordance with AS1869.

The fryer must be installed with a connector (not supplied by Vulcan) complying with the above codes.

The fryer must be installed with restraining means to guard against transmission of strain to the connector. See illustration.

The fryer must be installed with the casters provided.

If the restraint is ever to be disconnected, first turn the gas supply off.

The fryer comes with a NEMA 15-5P plug that requires 120 Volt service. Plug in the wire connection into an approved outlet.

VULCAN-HART

F-32934 Rev. B (June 2008)

-9-

Vulcan-Hart ML-136650 ML-136653, ML-136654, ML-136656, ML-136657, ML-136681 Electrical Connection

Models: 1G6BD 1G4BD ML-136647 2G8BDF 1G6BD ML-136648 1G8BD ML-136649 1G4BD 2G4BDF 2G6BDF 2XG4BDF 3G4BDF 3G6BDF 2XG8BDF 3G8BDF 4G6BDF 4G8BDF 2XG6BDF 4G4BDF ML-136655 ML-136649 ML-136650 ML-136653 ML-136647 ML-136648 ML-136652 ML-1 ML-136651 ML-136681 ML-136657 ML-136656 ML-136654

ELECTRICAL CONNECTION