GAS PRESSURE REGULATOR INSTALLATION
A gas pressure regulator is supplied with the griddle and must be installed. Install the regulator as close to the griddle on the gas supply line as possible. Make sure that the arrow on the underside of the regulator is oriented in the direction of gas flow to the griddle (Fig. 2) and the regulator is positioned with the vent plug and adjustment screw upright (Fig. 3). Check and set the gas pressure after the regulator is installed. The pressure should be set for 4” water column (W.C.) for natural gas and 10” W.C. for propane gas while all burners are on. It is recommended that a trained gas service technician with the necessary tools, instruments and skills perform the installation of the griddle and gas pressure regulator.
Fig. 2Fig. 3
The supply pressure (upstream of the regulator) should be
ELECTRICAL CONNECTIONS – 900RX MODELS
Electrical and grounding connections must comply with the applicable portions of the National Electrical Code and/or other local electrical codes.
Disconnect the electrical power to the griddle and follow lockout / tagout procedures.
Appliances equipped with a flexible electric supply cord are provided with a
Power supply for electric ignition is 120 volts, 1 amp, 50/60 Hertz, 1 phase.
Do not connect the griddle to electrical supply until after gas connections are made.
- 7 -