
Maintenance Instructions
cleaning
Cylinder Head Cooling Fins
It is essential for performance and longevity of the
DAnger
Make sure to keep hands clear of exhaust pipe, muffler, and moving parts when checking airflow.
Every 100 hours, inspect and clean the cooling fins (more often when operating in extremely dusty, dirty conditions). Remove the two (2) cooling fin access panels in the engine shroud and clean the cooling fins and external surfaces using compressed air. Make sure to reinstall the access panels before op erating the engine.
NOTE: If dirt is packed into the cooling fins it may be necessary to remove the engine shroud in order to thoroughly clean the cooling fins.
Engine Cooling
Fin Access Panels
Kohler Engine
Shroud
Engine Cooling Air
Intake Screen
Engine Cooling Air Intake Screen and
Cooling Fin Access Panels
IMPORTANT: Yearly, it is good maintenance prac- tice to remove the engine cooling shroud and clean the cylinder head cooling fins thoroughly to prevent overheating and extend engine life. Make sure cool- ing shroud is reinstalled properly. This procedure will require removing the engine from the chassis.
Check Airflow
with Hand
Cooling System Airflow
Grass Buildup in Mower Deck Housing
DAnger
Before raising or removing the mower deck for cleaning, stop the engine, remove the ignition key, and disconnect the spark plug wires.
1.Raise the deck lock lever handle on each side of the carrier frame and pull out to release car rier frame for tilting action.
2.Using the carrier frame lift handle, raise deck to the
Latch Connected
Latch
Hook
Deck Lock Lever
Deck Secured in TILT-UP Position
57