40 ■ Watlow MINICHEF 2000 Application 4
3. With [ready] on the display,place the food in the oven. Then press the Start/Stop
key (indicated by the rapidly flashing indicator light).
The Start/Stop key indicator will light up. Time will count down on the display.
The unit will run the following two-step cooking sequence:
Countdown time is displayed. It is the total of the programmed Time 1 plus Time 2.
Set point 1 and Fan 1 will run until Time 1 expires.
Set point 2 and Fan 2 will run until Time 2 expires.You will not see the switch-over
from Time 1 to Time 2.
4. Once the cooking sequence is complete, the unit will switch to the [`Ho1d]
sequence.
The display will alternate slowly between Hold and count up time.
If the Hold time parameter [Htine] has been set to 0, the unit will count up time
indefinitely.The hold sequence will end and the controller will go into idle when you
cancel the current menu by pressing the Start/Stop key.
If [Htine] is greater than 0, the unit will run the hold sequence until the hold
time expires. It will then switch to the sequence described in 5.
5. When the cooking cycle is finished, one of the following will happen, depending on
the way the controller was programmed at [Etype] / [sound] :
With Sound set to 0, the controller automatically switches to idle in which the con-
troller does not maintain temperature and does not run time. [`idle] or current
time will appear on the display.The Start/Stop key indicator light will be off.
With Sound set to 1, 2, or 3, [``end] will appear on the display and an audible
tone will be emitted. The Start/Stop key indicator light will flash rapidly. You can
acknowledge the tone by pressing the Start/Stop key or it will time out in 1 to 20
seconds and go into idle. The Start/Stop key indicator light will be off.
With Sound set to 4 or 5, [``end] will appear on the display and the Start/Stop
key indicator light will flash rapidly.You must acknowledge the audible signal by
pressing the Start/Stop key.Once acknowledged the audible signal is silenced and
the controller goes into idle. The Start/Stop key indicator light wil be off.
6. Once the controller goes into idle, the Start/Stop key indicator light and the heat
outputs will switch off.The controller will not regulate to any temperature.
7. To repeat cooking,repeat steps 1 through 4 or 5.
Run a Menu (without preheat feature)
This procedure describes how to run an active menu when the preheat feature is inac-
tive in other words, when the [ready] parameter in the [setUp] function of the
Configuration mode is set to [```no].
1. Select a menu as shown earlier.
2. With idle on the display,place the food in the oven.
3. Press the Start/Stop key.
The Start/Stop key indicator will light up. Time will count down on the display.
The unit will run the following two-step cooking sequence:
Countdown time is the total of the programmed Time 1 plus Time 2.