Weber 330, GAS GRILL LP Gas Grill, 54406 manual GAS INSTRUcTIoNS, Connect the Hose to the Cylinder

		GAS INSTRUcTIoNS
A)	Open base cabinet doors . Bring regulator and hose forward out of cabinet (1) .
B)	Locate hose retention clip (2) on regulator hose . Secure into slot (3) on underside of		1		3
	tank scale .			2
m WARNING: The hose must be secured to the tank scale
	with the Hose Retention Clip. Failure to do so could cause
	damage to the hose resulting in a fire or explosion which
	can cause serious bodily injury or death, and damage to
	property.
Some LP tanks have differing top collar assembles . (The top collar is the metal
protective ring around the valve .)		One series of tanks mount with the valve facing front

(4). The other tanks mount with the valve facing away from the fuel scale (5) . Weber recommends the use of cylinder manufacturer’s Manchester and Worthington, with a

47 .6 lb water capacity . Other cylinders may be acceptable for use with the appliance provided they are compatible with the appliance retention means (see illustrations) .

The LP cylinder is installed inside the base cabinet, on the tank scale (right side) .		4	5
C)	Loosen cylinder lock wing nut . Swing cylinder lock up (6) .
D)	Turn the LP cylinder so the opening of the valve is either to the front or side of the
	Weber® gas barbecue .
E) Lift tank up into position on the tank scale (7) .
F)	Swing the cylinder lock down . Tighten the wing nut .
Connect the Hose to the Cylinder
A) Remove the plastic dust cover from the valve .
B) Screw the regulator coupling onto the tank valve, clockwise, or to the right (8) .		6	6
	Hand-tighten only .

Note: This connection tightens clockwise and will not allow gas to flow unless the connection is tight.The connection requires tightening by hand only.

m WARNING: Do not use a wrench to tighten the connection.

Using a wrench could damage the regulator coupling and could cause a leak. ◆

7

8

10