mAINTeNANce
Burner Tube Removal
To remove burner tube(s):
A) Remove igniter wire(s) from igniter clip(s) (9) .9 B) Remove screw that holds burner tube to the cookbox using a 5/16"
C) Pull burner tube assembly (this includes igniter) up and out of cookbox (11) .
Note: 310 units will have an additional grounding wire attached to the center burner tube (12).
Burner Tube Cleaning
To clean the burner tube(s):
A)Look inside each burner with a flashlight (13) .
B)Clean the inside of the burners with a wire (14) (a
C)Check and clean the air shutter opening at the ends of the burners . Check and
clean the valve orifices at the base of the valves . Use a steel bristle brush to clean |
| |
outside of burners (15) . This is to make sure all the burner ports are fully open . | 11 | |
m CAUTION: Do not enlarge the burner ports when cleaning. | ||
|
Burner Tube Reinstallation
To reinstall burner tubes:
A) Slide burner tube and igniter wire through hole in cookbox (16) . Refer to “ELECTRONIC IGNITION SYSTEM OPERATIONS” for proper burner position .
B) Align burner tube with valve .
mCAUTION: The burner openings (17) must be positioned
properly over the valve orifices (18).
C)
D) Route wires back through igniter clips . Refer back to figure (9) .
m CAUTION: All wires must be properly routed through wire clips.
E) Attach wires to module, following the numerical/color coding (20) . Refer to “ELECTRONIC IGNITION SYSTEM OPERATIONS” for proper attachment of wires .
m WARNING: After reinstalling the gas lines, they should be leak checked with a soap and water solution before using the barbecue. (Refer to “CHECK FOR GAS LEAKS”.)
mWARNING: Make sure that all parts are assembled and
hardware is fully tightened before operating the grill. Your actions, if you fail to follow this Product Warning, may cause a fire, an explosion, or structural failure resulting in serious personal injury or death as well as damage to property. ◆
10
12
13
14
15
17
16
18
19
20
WWW.WebeR.com® 23
