Wegener Communications 1.5SECURITY LABELS, DVR395/DVR396 Interconnect Descriptions, Signal

Page 14

1.5SECURITY LABELS

The DVR395 incorporates security labels. There are no user serviceable components within the IRD (integrated receiver decoder). Tampering with the security labels, opening the units, will void your warranty. If you have questions, contact Wegener's customer service department at the address and phone (fax) numbers shown in Section 1.6 (Page 16) of this manual.

Table 2. DVR395/DVR396 Interconnect Descriptions

Signal	Connector	Description
RF IN	F	950 to 2150 MHz signal accepted
COMPOSITE	Phono Jack	NTSC or PAL
VIDEO OUT
S-VIDEO OUT	S-video	NTSC or PAL
AUDIO OUT	Two phono jacks	Audio stereo
SERIAL PORT	RJ-12	Serial Asynchronous Data. May be used for terminal,
		printer, modem, or local COMPEL control.
MODE SWITCH	4 Position DIP	Control DIP switches for NTSC/PAL; Modulator
		channel 2/3; Normal Video, Color Bars; and LNB
		Voltage ON/OFF.
ALARM	Terminal Strip	Receiver alarm contacts,
		Alarm : NC connects to COM
		NORMAL : NO connects to COM
CLOSURE	Terminal Strip	Solid state switch closures defined by the network
		control systems or equipment status.

Connect the receiver to the desired equipment as follows:

CHASSIS GROUND

Using #12 AWG or larger wire, connect the ground to a system or rack ground.

RF IN

Using 75 Ohm coaxial cable with a type F connector, connect your RF source to the RF IN connector.

* * * CAUTION * * *

When connecting cables to “F” type connectors apply a force of no more than 12 inch/lb. (Finger tight). Avoid connecting adapters directly to “F” type connectors. Use at minimum a 1-foot flexible extension cable between “F” type connectors and adapters.

DVR395/DVR396-002 Page 14 of 30