Page 17
SECTION 2
POWER ON PROCEDURES
2.1GENERAL
This section provides information and procedures for powering up the unit.
2.2CONTROL DIP SWITCHES
A four position DIP switch on the rear panel provides manual control and setup selection. Mode setting is as follows: (In setting the DIP switches, "D" = down and "U" = up, "X" = don't care for this function).
Table 4. Control DIP Switch Functions
Mode
Function
1 | 2 | 3 | 4 |
|
|
|
|
|
| Setup Functions |
|
|
|
| |||
U X X X | NTSC Video System* |
| |||
D X X X | PAL Video System* |
| |||
|
|
| |||
X U X X | Modulator Channel 3 | (MODEL SPECIFIC) | |||
X D X X | Modulator Channel 2 | (MODEL SPECIFIC) | |||
X X U X | Normal video |
| |||
|
|
| |||
X X D X | Color Bars, Tones |
| |||
X X X U | LNB Power OFF |
| |||
|
|
| |||
X X X D | LNB Power ON |
| |||
Set the switches to the settings appropriate for your system.
*The receiver must be set to the same format (NTSC or PAL) as the desired channel being received. The receiver will not operate correctly with incompatible settings.
2.3FRONT PANEL CONTROLS AND INDICATORS
The front panel indicators and controls are shown in Figure 4 (Page 18) and Figure 5 (Page 18), and described in Table 4 (Page 17).
Page 17 of 30 |
