Weider 831.159831 Pages 30 Identify the Butterfly Cable, Pulley BAG 2. Remove one V-Pulley, Shown

22. Identify the Right and Left Butterfly Arms (19, 20)			22	Bracket	7
by the positions of the welded brackets.
Press a 1 3/4” Square Inner Cap (68) into each				Lubricate
end of the Right Butterfly Arm (19). Wet the lower				Axles
end of the Butterfly Arm with soapy water. Slide a						Welded
Large Foam Pad (53) onto the lower end of the						Brackets
Butterfly Arm.
Lubricate the axles on the Butterfly Top Frame					68
(7). Orient the Right Butterfly Arm (19) as shown				19	54
and slide it onto the right axle. Have a second
person secure the Butterfly Arm with two 1”
Retainers (54) and a 1” Cover Cap (55).		Note:			55
Place the Retainers on top of the inverted					20
Cover Cap. Make sure the teeth on the
Retainers bend toward the Cover Cap, as				53
shown in the inset drawing. Gently tap the
Cover Cap onto the axle with a hammer.
Repeat this step with the Left Butterfly Arm (20).				68
					Axle
					54
					Teeth
					55
Cable Assembly			23
23. Locate and open the parts bag labeled
“CABLE ASSEMBLY.” For cable identification					77
and routing during steps 23 to 61, refer to the
CABLE DIAGRAMS and CABLE ID CHART on					Bracket
pages 30 and 31.				20
Identify the Butterfly Cable (73).		It is approxi-				73
mately 52” long and it has an eyelet on each end.
						84
Attach the Butterfly Cable to the bracket on the
Left Butterfly Arm (20) with a 5/16” x 1” Shoulder
Bolt (84) and a 5/16” Nylon Jamnut (77).
24. Locate and open the parts bag labeled			24		37
“PULLEY BAG 2.” Remove one “V”-Pulley (34)
from the bag. Leave the remaining pulleys in						34
the bag for identification of the Pro Pulleys.
Wrap the Butterfly Cable (73) around a “V”-Pulley
(34) in the direction shown. Attach the Pulley and					90
a Long Cable Trap (37) to	the bracket on the				73	105
back of the Butterfly Upright (4)		with a 3/8” x		4
2 1/2” Bolt (105) and a 3/8” Nylon Locknut (90).
Make sure the Long Cable Trap is oriented as
shown.

13