53.Wrap the Press Cable (72) around a 3 1/2” Pulley
(35)in the direction shown. Attach the Pulley and
a Cable Trap (38) to the indicated hole on the right side of the Press Upright (5) with a 3/8” x 4 3/4” Bolt (102) and a 3/8” Nylon Jamnut (92).
Note: Thread the Jamnut only two turns onto
the Bolt; another Pulley will be attached to the Bolt in step 57. Make sure the Cable Trap is positioned to hold the Cable in the groove of the Pulley.
54. Route the Press Cable (72) through the Press
Frame (17) and around a 3 1/2” Pulley (35) as shown. Attach the Pulley and a Cable Trap (38) to
the indicated hole on the right side of the Leg Press Lever (14) with a 3/8” x 4 3/4” Bolt (102)
and a 3/8” Nylon Jamnut (92). Note: Thread the
Jamnut only two turns onto the Bolt; another Pulley will be attached to the Bolt in step 56. Make sure the Cable Trap is positioned to hold the Cable in the groove of the Pulley.
55.Wrap the Press Cable (72) around a “V”-Pulley
(34)in the direction shown. Attach the Pulley and a Long Cable Trap (37) underneath the Press
Seat Frame (12) with a 3/8” x 4 1/4” Bolt (85), a 3/8” Washer (97), and a 3/8” Nylon Locknut (90).
Note: the Press Seat Frame has five adjust- ment holes. Attach the Pulley to the second hole from the Leg Press Lever (14). Make sure the Cable Trap is positioned to hold the Cable in the groove of the Pulley.
56.Remove the 3/8” Nylon Jamnut (92) used in step 54.
Wrap the Press Cable (72) around a 3 1/2” Pulley (35) in the direction shown. Slide a Cable Trap
(38)and the Pulley onto the 3/8” x 4 3/4” Bolt
(102)in the Leg Press Lever (14). Properly tight- en the 3/8” Nylon Jamnut (92) onto the Bolt.
Make sure the Cable Trap is positioned to
hold the Cable in the groove of the Pulley.
53 |
|
|
| 102 | 92 |
| 72 | |
|
| |
| 35 | 5 |
|
| |
| 38 | |
54 |
|
|
102 | 72 |
|
35 | 92 |
|
38 |
| |
14 |
|
|
55 |
|
|
85 |
| |
97 |
| |
12 | 38 |
|
72 | 34 |
|
14 | 90 |
|
|
| |
56 |
|
|
14 |
|
|
102 |
|
|
| 92 | 72 |
| 3835 |
|
21
