Contents
Patent Pending
Model No Serial No
Serial Number Decal
SEARS, Roebuck and CO Hoffman ESTATES, IL
Table of Contents
Important Precautions
Before YOU Begin
Using the Power Stack weight system
Decal
To open the parts bag for that stage
Assembly
Cable Assembly
Arm Assembly
Locate and open the parts bag labeled
Frame Assembly
Tape over the head of each Bolt
109
Onto the Bolts. Do not tighten the Nylon Locknuts yet
100
Do not Tighten the Nylon Locknuts yet
Yet
Locknuts 86. Do not tighten the Nylon Locknuts yet
On bottom
Press a 2 Square Inner Cap 67 into the Press Top Frame
Into
On the bottom
On the Short Weight Tube
Nylon Jamnuts
Must be behind the Center Top Frame, as shown in step
Locknuts 90. Do not tighten the Nylon Locknuts yet
Nylon Locknuts yet
Assembly
Bracket on
Pages 30 Identify the Butterfly Cable
Pulley BAG 2. Remove one V-Pulley
Bag for identification of the Pro Pulleys
Identify the Rear Cable
Labeled Pulley BAG
Bracket On the back of the Butterfly Upright
Ed as shown
Large tabs
Identify the Ab Cable 74. It is approximately
Pulley and the pin on the Upright
103
Groove of the Pulley
Remove the 3 1/2 Pulleys 35 from the other
Make sure
Is attached as shown
Direction shown
Be removed in step
Pulley
Hold the Cable in the groove of the Pulley
Identify the Low Cable 71. It is approximately
Cable in the groove of the Pulley
Pulley and the pin on the Press Top Frame
Cable Trap 38 to the 3/8 x 4 3/4 Bolt
With the 3/8 Nylon Jamnut
Identify the Press Cable 72. It is approximately
Wrap the Press Cable 72 around a V-Pulley
To hold the Cable in the groove of the Pulley
Wrap the Press Cable 72 around a 3 1/2 Pulley
Pulley onto the 3/8 x 4 3/4 Bolt
Route the Press Cable 72 through the Press
102 3835
With a 3/8 Nylon Jamnut 92. Make sure
Locate and open the parts bag labeled Seat
Seat Assembly
ADJUSTMENTS, beginning on the following
Adjustment Pin 40. Note The lip on
Leg Press Plate 16 must be on the upper edge
Attaching the Curl PAD
Adjustments
Attaching the Accessories to a Pulley Station
Adjusting the LEG Press Plate
To change the setting of a weight stack, insert a
Changing the Weight Setting
Weight stack. Turn the bent end down
Lbs Left Top
Weight Resistance Chart
High Press LEG
LEG LOW Pulley ARM Press
Tightening the Cables
Troubleshooting and Maintenance
Hole with the Bolt, Washer, and Nylon Locknut 104
Cable ID Chart
Cable Diagrams
70, 95 1/8 71, 142 1/8 74, 226 1/2 72, 387 5/8
Low Cable Rear Cable Ab Cable Butterfly Cable
SEARS, Roebuck and CO., Hoffman ESTATES, IL
Full 90 DAY Warranty
SEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, IL
This
R0502A
Part Identification CHART-Model No
Page
Round Inner Cap
Save this Part LIST/EXPLODED Drawing for Future Reference
Qty Description Key No. Qty
Exploded DRAWING-Model No