6.Attach the upper ends of the Weight Guides (9) to the Top Frame (10) with the 5/16” x 6” Bolt (91), two 1/2” x 3/4” Spacers (39), and a 5/16” Nylon Locknut (83).
See the inset drawing. Be sure that the Pulley Bracket (51) is in front of the right Weight Guide (9).
Arm Assembly
7.Press a 1” x 7/8” Plastic Bushing (40) onto each welded spacer on the Press Frame (13). Slide the Press Frame into place on the Base (2). Note:
This will be a tight fit. The Plastic Bushings should fit onto each end of the indicated tube in the Base. Be sure that the holes are on the indicated side of the Press Frame.
Lubricate the 3/8” x 8” Bolt (71). Attach the Press Frame (13) to the Base (2) with the Bolt and a 3/8” Nylon Locknut (84). Do not overtighten the
Nylon Locknut; the Press Frame must be able to pivot freely.
8.Press a 1 3/4” Square Inner Cap (56) into the top of a Press Arm (14). Press a 1” Round Inner Cap
(61)into the end of the handle on the Press Arm.
Attach the Press Arm (14) to one side of the Press Frame (13) with two 5/16” x 2 1/2” Bolts (80) and two 5/16” Nylon Locknuts (83).
Assemble the other Press Arm (14) in the same manner.
9.Identify the Left Arm (11) and the Right Arm (12). Note the position of the welded bracket on each Arm. Arm identification is very important for step 10.
Press 1 3/4” Square Inner Caps (56) into the lower ends of the Left and Right Arms (11, 12). Wet the end of each Arm with soapy water, and slide a 10” Pad (62) onto each Arm.
8
6 |
|
| 39 |
|
| 91 | |
|
| 10 | |
|
|
| 83 |
| 51 |
|
|
| 9 |
| 9 |
|
|
| |
7 |
|
|
|
| 13 | Holes |
|
| 84 |
|
|
| Welded | 71 |
|
| Spacers |
| |
|
| Lubricate | |
| 40 |
| |
|
|
| |
| 2 | Tube |
|
|
|
| |
8 | 56 |
|
|
|
|
| |
| 61 |
|
|
|
|
| 14 |
| 14 |
|
|
| 13 | 80 |
|
| 83 |
|
|
9 |
|
| Welded |
|
|
| |
|
|
| Brackets |
| 12 |
|
|
| 62 |
|
|
|
|
| 11 |
| 56 |
| 62 |
|
|
| |
| 56 |
| |
