2.Attach a Wheel (31) to the outside of the Base (1) with an M10 x 108mm Bolt (81), three M10 Washers (75), and an M1O Nylon Locknut(76). Do not overtighten the Nylon Locknut; the Wheel must be able to turn easily.
Attach the other Wheel (not shown) in the same manner.
3.Press a 38mm x 64mm inner Cap (41) into each end of the Cross Tube (11).
Orient the Cross Tube (11) as shown, with the welded tubes at the bottom.Attach the Cross
Tube to the Upright (3) with two M10 x 140mm Carriage Bolts (73), two M10 Washers (75), and two M10 Nuts (47).
4.Press a 38mm x 76mm Inner Cap (99) into the top of the Front Leg (6). Press the Front Leg Foot
(27)onto the bottom of the Front Leg. Note that the front of the Front Leg Foot is taller than the back.
Press a 38mm x 76mm Inner Cap (99) into the end of the Bench Rail (5).
Attach the Bench Rail (5), with the hook on the bottom, to the Front Leg (6) with two M10 x
75 47
Welded
73
11
41
995_9
53mm Carriage Bolts (61) and two M10 Nylon
Locknuts (76).
5. Lubricate an M10 x 103mm Bolt (66) with grease. |
Attach the Bench Rail (5) to the Upright (3) with |
the Bolt and an M10 Nylon Looknut(76). Do not |
overtlghten the Locknut; the Bench Rail must |
Fron_
3O
be able to pivot easily. |
Tighten the Storage Knob (30) into the Upright (3) |
and the Bench Rail (5). |
Insert the bolt | 76 |
through this hole
Lubricate
6