16.Locate the Crossbow Fulcrum (18) on the Lat Tower (4) (see the inset drawing). Slide the
Crossbow Spacer (35) onto the rods on the Crossbow Fulcrum. Make sure the Spacer is oriented as shown in the drawing.
Set the Crossbows intothe CrossbowSpacer (35) in the followingorder: the
Crossbow(67), the
Crossbow(95), and the
Attach the Crossbow Cover Plate (72), with the edges up, to the Crossbow Spacer (35) with two
M8 x 19mm Button Head Screws (86).
17.Locate the Long Cable (80). Insert one end of the Cable through the welded tube on the indicat- ed end of the Cross Tube (11) and then through a Swivel Arm (22). If necessary, use the tip of a screwdriverto pull the end of the Cable out of the
Swivel Arm. Be sure the Cable Is on the indicat- ed side of the welded rod In the Swivel Arm.
Insert the Swivel Arm (22) into the welded tube on the Cross Tube (11). Secure the Swivel Arm with an M4 x 5ram Screw (104).
Wrap the Long Cable (80) around a 90mm Pulley
(28).Attach the Pulley inside of the Swivel Arm
(22)with an MIO x 42ram Button Head Bolt (71) and an M1O Nylon Locknut (76).
18.Wrap the Long Cable (80) around a 90mm Pulley (28). Attach the Pulley and a Pulley Guard (29) to the indicated M1O x 140mm Carriage Bolt (73) with an M10 Nylon Locknut (76). Be sure the fiat
edge of the Pulley Guard is on the side shown.
19.Attach a Pulley Housing (94) to the indicated"U"- channel on the
Pivot Bushings (74), and an M10 Nylon Locknut (76).
Wrap the Long Cable (80) around a 90mm Pulley (28). Attach the Pulley inside of the Pulley Housing (94) with an M10 x 42mm Button Head
Bolt (71) and an M10 Nylon Locknut (76).
1686
up
96
Rings on
95
Rods 67
17
0 7110,
28--_q
76
18
Flat
Edge 2._,/76
19_.Channel
10
