Weider XR20 user manual TROUBLE-SHOOTING and Maintenance, Tightening the Cables

TROUBLE-SHOOTING AND MAINTENANCE

Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The home gym system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the home gym system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened.

Slack can be removed from the cables by tightening the Long Cable (23) (see drawing 1). To tighten the Long Cable, first loosen the 1/2Ó Plain Nut (81). Next tighten the end of the Long Cable further into the Weight Tube (63). Tighten the 1/2Ó Plain Nut against the 1/2Ó Flat Washer (82).After tightening the Long Cable, you must also tighten the 1/2Ó Plain Nut (81) against the 1/2Ó Flat Washer (82).

To remove slack from the Medium Cable (58), tighten the 1/2Ó Nylon Locknut (2) on the Long ÒUÓ Bracket (57). To do this you may need to remove the Long Cable (23) from the Weight Tube (63) or remove the 3 1/2Ó Pulley (15) from the Long ÒUÓ-Bracket (57).

Additional slack can be removed by moving the 3 1/2Ó Pulley (15) to the other hole in the Long ÒUÓ-Bracket (57). Remove the 3/8Ó Nylon Locknut (21) and the 3/8Ó x 2Ó Bolt (12) from the Cable Trap (66), Pulley, and Long ÒUÓ-Bracket. Re-attach the Pulley and Cable Trap. Be sure that the Cable Trap is in the proper position and that the Cable and Pulley move smoothly.

Make sure that the cables are not too tight, or the Top Weight (76) will be lifted off the weight stack.

If the cables need to be replaced, see the back cover of this manual.

1	23	76
	81
	82
	63
2
23
	15
66	57
21	12
2	58

20