MAINTENANCE INSTRUCTIONS (continued)
C. HINGE ADJUSTMENT
1.The hinges provide the pivot for the door, allow for height adjustment and alignment so that the door closes properly on the gasket.
2.To access the hinge adjustments:
a.Remove the grease tray. Remove the upper trim panel by removing the four screws at the ends of the panel. The trim panel / grease tray support assembly will then pull straight out.
b.Remove the bottom trim panel by removing the four screws at the ends of the panel, and by loosening the two screws holding the bottom door gasket. The panel will then pull straight out.
3.The door should be approximately centered between the upper and lower lips of the cabinet. Adjust the door for height:
a.The hinge sleeve acts as a jam nut for the height adjuster.
b.The top and bottom clearances should be approximately equal. If necessary, loosen the hinge sleeve and turn the height adjustment nut until the required clearances are achieved.
c.Retighten the hinge sleeve.
4.Check
5.To adjust a top or bottom hinge:
a.Loosen the holding bolts.
b.Tighten or loosen the adjusting bolt as needed to achieve the proper vertical clearances.
c.Retighten the holding bolts.
d.Recheck the clearances. Recheck the tightness of the bolts.
6.Reassemble the trim panels. Remember to retighten the screws for the lower gasket
CLEARANCES
EQUAL
APPROXIMATELY
TOP PANEL
CHECK ALIGNMENT
BOTTOM
PANEL
| HINGE SLEEVE |
HINGE BRACKET | HINGE BRACKET |
HOLDING | HOLDING |
BOLTS | BOLTS |
DOOR PIVOT | HEIGHT |
ADJUSTING | ADJUSTMENT |
BOLT | ADJUSTING |
| |
| BOLT |
23