INSTALLATION REQUIREMENTS

ToolsandParts

Assemble the necessary tools and supplies before beginning the washer installation. The parts supplied are in the washer basket. Do not put the expanded foam plug back into the washer.

Tools needed for connecting the drain hose and water inlet hoses

Pliers that open to 1 ⁹⁄₁₆" (3.95 cm)

Flashlight (optional)

Parts supplied:

ABC

A. Drain hose “hook”

B. Water inlet hoses (2)

C. Flat water inlet hose washers (4)

Tools needed for securing the drain hose and leveling the washer

Adjustable or open end wrench ⁹⁄₁₆" (14 mm)

Level

Wood block

Ruler or measuring tape

Parts supplied:

A

BC

A. Beaded tie strap

B. Front leveling feet with nuts (2)

C. Rear self-adjusting feet (2)

Alternate Parts You May Need

Your installation may require additional parts. If you are interested in purchasing one of the items listed here, call the toll-free number on the cover or in the “Assistance or Service” section.

If You Have

You Will Need to Buy

 

 

Laundry tub or

Sump pump system (if not already

standpipe taller

available)

than 96" (2.4 m)

 

 

 

1" (2.5 cm)

2" (5 cm) diameter to 1" (2.5 cm)

diameter

diameter standpipe adapter,

standpipe

Part Number 3363920

 

 

Overhead sewer

Standard 20 gal. (76 L) 39" (99 cm) tall

 

drain tub or utility sink and sump pump

 

(available from local plumbing suppliers)

 

 

Floor drain

Siphon break, Part Number 285834;

 

additional drain hose,

 

Part Number 8318155 and connector

 

kit, Part Number 285835

 

 

Drain hose too

Drain hose, Part Number 8329541 and

short

connector kit, Part Number 285835

 

 

Lint clogged drain

Drain protector, Part Number 367031

 

and connector kit, Part Number 285835

 

 

Water faucets

2 longer water fill hoses:

beyond reach of

6 ft (1.8 m) Part Number 76314,

fill hoses

10 ft (3.0 m) Part Number 350008

LocationRequirements

Selecting the proper location for your washer improves performance and minimizes noise and possible washer “walk.”

Your washer can be installed in a basement, laundry room, closet, or recessed area. See “Drain System.”

IMPORTANT: Do not install or store the washer where it will be exposed to the weather.

Proper installation is your responsibility.

You will need:

A water heater set to deliver 120°F (49°C) water to the washer.

A grounded electrical outlet located within 4 ft (1.2 m) of where the power cord is attached to the back of the washer. See “Electrical Requirements.”

Hot and cold water faucets located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of 20-100 psi (138-690 kPa).

A level floor with a maximum slope of 1" (2.5 cm) under entire washer. Installing the washer on carpeting is not recommended.

A sturdy floor to support the washer weight (washer, water and load) of 315 lbs (143 kg).

Do not store or operate your washer in temperatures at or below 32°F (0°C). Some water can remain in the washer and can cause damage in low temperatures. See “Washer Care” for winterizing information.

4

Page 4
Image 4
Whirlpool GVW9959KL0 manual Installation Requirements, ToolsandParts, LocationRequirements, Alternate Parts You May Need