6. Touch START. | The AUTO SETand | PROBE TEMP |
| |
| Indicator Lights will stay on. |
| ||
| The Display will show “COOL” to | |||
| show the food is less than 90°F |
| ||
| As the food cooks the Display will | |||
| show the | internal temperature | of | |
| the food | for every | 5°F increase. |
|
For 2 of every 10 seconds, the Display will show the Cook Power you selected, if you are using a Cook Power other than high.
When the probe senses the tem- perature you selected, the oven shuts off. “End” will show on the Display and 4 beeps will sound. [You can stop the beeping by opening the door or by touching CANCEL.) “End” will remain on the Display and a beep will sound every 30 seconds (to remind you that food is left in the oven] until door
is opened or CANCEL is touched. The Display will then show the time of day.
NOTE: You can set Auto Set TEMP to follow COOK.
Auto Set TEMP can be programmed with the temperature probe out, but the oven will pause between the last Cook cycle and TEMP’PROB” will show on the Display to remind you to plug in the probe.
Changing the pre-programmed setting
You can change the
1.Insert at least% of the temperature probe into the food.
2.Place food in the oven and close the door.
3.Touch TEMP twice.
4.Touch the Number Pads for the new desired temperature between 90 ‘Fand 200 F If high Cook Power is desired, skip to Step 6.
5.Touch COOK POWER.
6.Touch the Number Pad for the desired Cook Power.
7.Touch START.The oven will cook to the new temperature at the Cook Power you selected. After the cooking is complete, the oven will remember that temperature and Cook Power for future use. NOTE: If the electric power goes off, the oven will go
back to the
Additional information:
l Temperature may be changed after STARTis touched by touching TEMP the new number and START.
. Auto Set TEMP will follow the COOK cycle if programmed.
l “PROB”will show on the Display after STARTis touched if the probe ISnot plugged
into the oven. This will only appear when Auto Set TEMP has been selected atone, or between the last COOK cycle and Auto Set TEMP selection,
l “ERR”will show on the Display after STARTis touched, if an incorrect temperature has been selected [under 90 F or over 2OO’F).
l See “Hintsfor using the temperature probe” on pages 18 and 19.
14
