1.Be sure surface unit controls are OFF.
Receptacle
\ Opening /
2.Line up opening in the reflector bowl and notch in trim ring with the surface unit receptacle.
Terminal
3.Hold the surface unit as level as possible
with the terminal lust started into the receptacle.
4.While pushing the surface unit terminal into
the receptacle, lift a little on the edge of the unit nearest the receptacle.
5.When the terminal is pushed into the re- ceptacle as far as it will go, the surface unit will fit into the trim ring.
Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer.
If a trim ring gets discolored, some of the utensils used may not be flat enough. Or some may be too large for the surface unit. In either case, some of the heat that is meant to go into or around a utensil goes down and heats the trim ring. This extra heat can discolor it.
31
