Whirlpool SF365BEXN0 manual Fluorescent Light Some Models, Oven Light Some Models

Fluorescent Light (Some Models)

A switch on the control panel turns the cooktop lamp on and off

Some models have a cooktop lamp that is located below the control panel. This lamp must be replaced by a service repreaentativne.

On models with a lamp and canopy above the control panel. the lamp may be replaced from the front of the range.

To replace the lamp:

I.Turn power off at the main source or unplug the range.

2. Tilt back the hinged lamp cover above the control panel.

3. Remove the lamp by,rolling up and bath. Install the nevvone by sliding down into place.

3. Lower the hinged lamp cover.

Oven Light (Some Models)

The ov’cn light (some models) automatically tut-nson when the door is opened. Use the switch located on the control panel IOturn the light on when the door is closed. The oven light is located at the rear of the oven and is covered with a glass shield. The glass shicid must be in place whenev,er the ov’en is in use.

To replace the light:

I. Turn power off at the main source or unplug the range

~ACAUTION~1 Be sure the oven is COOL. Wear a leather fxed glove for pro- tection against possible broken glass.

2.Press wire holder to one side to release the glass shield.

3.Replace bulb with a 10 watt appliance bulb.

4.Replace glass shield in socket and snap wire holder into place.

Be sure that all burners are off and cool before replacing the oven light. Be sure that the range top is cool before replac- ing the fluorescent bulb.