Water Softener Setup
TOUCH SCREEN
Controls for programming the water softener are dis- played on a touch screen, located on the softener’s front panel (See Figure 17).
fingerprints, unplug the transformer. The con- troller’s memory items (including clock time, water hardness, etc.) are retained during brief power interruptions. Use a microfiber towel or household cleaner safe for plastics on the touch screen.
SETUP PROCEDURE
When the softener is plugged in for the first time, a beep sounds and the display briefly shows
Next, a series of three setup screens prompts you to enter basic operating information:
FIG. 15
1. LANGUAGE: If the desired language is not checked (See Figure 15), press the button next to the desired language, then press the NEXT button.
FIG. 16
2. CURRENT TIME: Press the DOWN ( ) or UP ( ) buttons to set the current time (See Figure 16). Hold the button down to rapidly advance. Be sure AM or PM is correct. When the current time is shown, press the NEXT button.
Touch
Screen
FIG. 17
FIG. 18
3. WATER HARDNESS: Press the UP ( ) or DOWN ( ) buttons to set the value of your water’s hard- ness (See Figure 18), then press the NEXT button. NOTE: Do not increase the hardness setting to com- pensate for iron in your water. The electronic
control will compensate automatically after you set the iron level, as described on Page 17.
FIG. 19
4. If, at this point, you want to go back and make changes, press the button next to NO, then press the NEXT button to repeat the three setup screens.
5. If no changes are desired, make sure the button next to YES is checked and press the NEXT but- ton. The softener begins normal operation, described on the next page.
Questions? Call Toll Free
or visit www.ecodynewatertreatment.com
When you call, please be prepared to provide the model, date code and serial number, found on the rating decal, typically located on the rim below the salt lid hinges.
12