Whirlpool WHES48 operation manual Schedule a Recharge, Setup Button, SET Time

Programming Your E-Z Touch Water Softener

SCHEDULE A RECHARGE

To schedule a recharge for the next preprogrammed recharge time (2:00 a.m., or as set on Page 15):

1. Press the RECHARGE button at the bottom of the softener status screen (See Figure 37).

FIG. 37

2. The display will change to show the following screen.

FIG. 38

3. Press the LEFT ( ) button. The display will change to show the following screen.

FIG. 39

4. Press the SCHEDULE RECHARGE button. The display will change to show the screen in Figure 40.

FIG. 40

5. Press the button next to ON, then press the RETURN ( ) button. The display will go back to the screen shown in Figure 39.

6. To return to the softener status screen, press the RETURN ( ) button.

FIG. 41

SETUP BUTTON

The SETUP button on the softener status screen is used to set items of basic operating information: =Set current time

=Set water’s hardness =Set recharge time =Set water’s iron level

=Advanced setup (Accesses more items that can be set. These are described starting on Page 19) =Set language

SET TIME

When the softener’s electronic control is first powered up, the setup procedure prompts you to set the cur- rent time (See Page 12). To change the time at a later date, such as after a long power loss:

1. Press the SETUP button on the softener status screen (See Figure 42).

FIG. 42

2. Press the SET TIME button (See Figure 43) and the display will change to show the Set time screen (See Figure 44).

FIG. 43

FIG. 44

3. Press the DOWN ( ) or UP ( ) buttons to set the current time. Hold the button down to rapidly advance. Be sure AM or PM is correct (unless sof- tener is set for a 24-hour clock). When the current time is shown, press the RETURN ( ) button.

4. To return to the softener status screen, press the RETURN ( ) button.

16