the wall and remove the battery for at least two minutes. After reinstalling the battery, the thermostat will revert to the factory pre- set program until you reprogram the ther- mostat. If you don’t want to reprogram the
thermostat immediately, press | SYSTEM | un- |
SWITCH |
til OFF is displayed and replace the thermo-
stat on the wall. Then press PRGMRUN to begin the factory preset program.
To prevent further static discharge prob- lems, touch another object to release static
7.Why won’t the setpoint temperature go to the temperature I want?
In the AUTO mode, the highest heating setpoint temperature you select must be at
least 1°F lower than the lowest cooling setpoint temperature you select (for ex- ample, if 70°F is your lowest selected cool- ing temperature, you cannot select a heat- ing temperature any higher than 68°F). If such a conflict exists, set the lowest cooling temperature higher in order to set the heat- ing temperature higher. To set a lower cool- ing temperature, you must select a lower heating temperature. See PROGRAMMING YOUR THERMOSTAT.
8.Why doesn’t the display light come on when I press a button? Why don’t I hear a beep when I press a button?
The display light and audio prompting (beep) only work when the thermostat is on the wall and 24vAC power is present to the thermo- stat. See OPERATING YOUR THERMO- STAT.
35
