Wintal DVDRX160 manual Component Video Connection, VIDEO Connection Television

S-Video Connection

This is a higher quality connection than standard composite video, and requires a special S-Video cable (not included). The S-Video connector is distinguishable by its 4 pins, as shown below. If your

TV has an S-Video input jack, it’s recommended that you use this type of connection for better picture quality.

		SVIDEO CONNECTION
TELEVISION		1.	Use a S-Video Cable, connecting the
				S-Video output from your DVDRX160 to
				the corresponding input on your TV
		2.	Turn on the unit and select ‘DVD Mode’
		3.	On your TV select the S-Video Input.
				This is normally done by pressing ‘TV/AV’
				or ‘MODE’ on the remote. Consult your
				TV manual for further instructions on
				how to do so.
	S
DVDRX160

Component Video Connection

The highest quality connection, Component video, requires three separate cables for the video connection (red green and blue). Component video can output in two modes: YCrCb (interlaced) and YPrPb (progressive scan). Progressive scan will yield a higher quality image, however, some televisions will not support this mode (consult your manual before attempting to output progressive mode).

TELEVISION

COMPONENT CONNECTION

1. First, connect a component lead (not included) from the YCb/Pb Cr/Pr terminals on the DVDRX160 to the component input on your TV. If you wish to use progressive scan, ensure that you connect to a YPbPr input.

2.Select the component input on your TV

(consult your manual for more information) 3. To switch between interlaced and progressive

scan modes, press PSCAN on the remote, then

SELECT.

DVDRX160

PROGRESSIVE SCAN: RESETTING THE VIDEO OUTPUT

If you inadvertently switch the OUTPUT FORMAT setting to PROGRESSIVE while using a

standard TV not capable of PSCAN, you will lose video. If this happens, reset the recorder to its default video settings by pressing PSCAN and SELECT on the remote.

12