DEALER SERVICE Cont’d
Install Drive Pulley
1.Install drive pulley (19) with split taper bushing (12) on gearbox vertical shaft. Make sure key (82) and keyways are aligned.
2.Position center line of drive pulley (19) 15/16" (plus or minus 1/32") above mounting surface of gear- box stand (20) as shown. This is a very critical dimension and must be held.
3.Alternately tighten split taper bushing set screws to 14
20
1-7/8"
19
82 12
15/16"DB2938
Figure 20 Drive Pulley Dimensions
NOTES
26 Dealer Service | MAN0137 (9/14/01) |
|