Assembly Instructions Cont’d
Assemble Mechanical Lift Pull Rod
1.Thread jam nut (17) onto pull rod (7) until it bot- toms out.
NOTE: For tractor models 7000, 7200, and 7205, use pull rod (7A) with bend up to clear hydraulic line.
2.Thread clevis yoke (8) onto pull rod (7) to obtain a
3.Attach pull rod assembly (17) to lug (21) on left rear rockshaft (6) and secure with washer (15) and cotter pin (16).
4.Connect clevis yoke (8) to front rockshaft (1) with clevis pin (12) and secure with cotter pin (16). Do not spread pin at this time.
5.Remove left lower
1.Front rockshaft assembly
2.Left front lift stop
3.Rear pull rod
4.Lift mounting plate assembly
5.Rear lift arm assembly
6.Left rear rockshaft assembly
7.Pull rod (7192, 7194, 7195) or
7A. Pull rod (bent) (7000,7200,7205)
8.Adjustable clevis yoke
9.
10.Klik pin
11.1/2 x
12.1/2 x
13.5/8" Flat washer
14.5/8 x 1.65" Clevis pin
15.1/2" Flat washer
16.3/16 x
17.1/2" Jam nut
19.12mm Bolt
20.ROPS
21.Lug
6.Remove the three axle housing bolts (19) and replace lift mounting plate (4) with the lift mounting plate supplied with mower lift kit.
7.Reinstall the three 12mm bolts and torque to 75
8.Slide rear lift arm assembly (5) over lower
(4). Secure with Klik pin (10).
9.Thread clevis yoke (8) onto rear pull rod (3) to obtain 16.5" length.
10.Connect rear pull rod (3) to rear rockshaft (6) using clevis pin (14) and secure with washer (13) and cotter pin (16).
11.Connect clevis yoke (8) to rear lift arm assembly
(5) with clevis pin (11) and cotter pin (16).
DC4203B
Figure 28 Mechanical Lift Pull Rod Assembly
MAN0137 (9/14/01) | Assembly 35 |
|
|