DEALER CHECK LISTS
PRE-DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY)
Inspect cutter thoroughly after assembly to be certain it is set up properly before delivering it to customer. The following check list is a reminder of points to inspect. Check off each item as it is found satisfactory, correc- tions made or services performed.
___ Check all bolts to be sure they are tight.
___ Check that all cotter pins are properly installed and secured.
___ On
___ Check that PTO shaft is properly installed.
NOTICE
■Gearbox was not filled at factory. It must be serviced before operating cutter. (See page 18.) Failure to service will result in damage to gearbox.
___ Check that gearbox is properly serviced and seals are not leaking.
___ Lubricate cutter.
___ Check that blades have been properly installed.
DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY)
___ | Show customer how to make adjustments. |
___ | Explain importance of lubrication to customer and |
| point out lubrication points on cutter. |
___ | Point out safety features and options. |
___ | For mounted units, add wheel weights, ballast in |
| front tires, and/or front tractor weight to enhance |
| front end stability. A minimum 20% of tractor and |
| equipment gross weight must be on front tractor |
| wheels. When adding weight to attain 20% of |
| tractor and equipment weight on front tractor |
| wheels, you must not exceed the ROPS weight |
| certification. Weigh the tractor and equipment. Do |
| not estimate! |
___ | Give Operator's Manual to customer and recom- |
| mend that customer become familiar with all sec- |
| tions, especially the safety information. |
___ | Explain to customer that when transporting cutter |
| on road or highway, day or night, safety devices |
| should be used to provide adequate warning to |
| operators of other vehicles. |
36 Dealer Check Lists | 15914 (Rev. 5/11/2007) |
|
|
