Woods Equipment MD80-2 manual Wheel Yoke Installation for D80-2 Pull-Type Cutter

Wheel Yoke Installation for D80-2 Pull-Type Cutter

The wheel yoke for use with pneumatic tires is illus- trated. The spring-loaded wheel yoke installs the same.

Attach wheel yoke (6) to rear of cutter frame with clevis pins (15) and cotter pins (3) at two points.

Insert crank (11) through pivot block (10). Slide sleeve

(7)onto crank, align hole in sleeve and hole in crank, and drive the spirol pin (8) into the assembly to attach.

Thread pivot nut (2) onto crank (11) until it will install into pivot lug (1), then attach with cotter pin (3). Install

spirol pin (4) into crank (11) to prevent crank detach- ment.

Attach axle with rim (12) and tire (not supplied) to wheel yoke using lock washer (13) and nut (14).

NOTICE

■You must use the pneumatic tire with this wheel yoke. The solid tire may be used with the spring-loaded wheel yoke.

1.Pivot lug

2.Pivot nut

3.1/4 x 1-1/2" Cotter pin

4.1/4 x 1" Spirol pin

5.Grease fitting

6.Wheel yoke

7.Sleeve

8.5/16 x 1-3/4" Spirol pin

9.Thrust bearing

10.Pivot block

11.Crank

12.Rim (tire not supplied)

13.1" Standard lock washer

14.1" Nut

15.1 x 2-1/2" Clevis pin

Figure 23. Wheel Yoke Installation

30 Assembly 15914 (Rev. 5/11/2007)