Woods Equipment MD80-2 manual Owner Service, Blade Removal

Ref
No	Description	Frequency
1	Tailwheel Hub (Towed Model)	10 hrs
2	Tailwheel Pivot Arm	8 hrs
3	Tailwheel (Mounted Model)	8 hrs

4Blade Spindle - Access through hole in end of belt shield (right);

	Remove left belt shield (left)	10 hrs
5	Belt Idler - Access through hole
	in top of belt shield (right);
	Remove left belt shield (left)	50 hrs
6	Gearbox: Fill with EP90 gear
	lube	Check Daily

7	Rear U-Joint	8 hrs
8	Slip Joint (Mounted Model) -
	Apply grease to all four sides
	of shaft	8 hrs
9	Front U-Joint	8 hrs
10	Center U-Joint (Towed Model)	10 hrs
11	Driveline Carrier Bearing
	(Towed Model)	10 hrs

12Slip Joint (Towed Model) - Apply grease to all four sides

	of shaft	10 hrs
13	Height Adjustment Pivot Block	Occasionally
14	Height Adjustment Crank	Occasionally

Figure 8. Lubrication Points

Blade Removal

Rotate crossbar until blade pin assembly is directly below access hole in rear of cutter frame. Remove bolt

(1)and blade pin clip (2). Slide keyhole plate (3) out of blade pin groove and remove. Remove spacers and drive pin out of crossbar. See Figure 7.

15914 (Rev. 3/23/2007) Owner Service 19