Mitsubishi Electronics SDP-ECO 1630 III On Safety, When using the machine, Grounding connection

Chapter1 On Safety

Chapter 1 On Safety

SDP-Eco 1630 III was designed and manufactured with special attention to safety considerations. However, it is impossible either to eliminate all potential sources of danger from such products or to anticipate all possible hazards and misuses. It is therefore critical that you both familiarize yourself, all your operators and other relevant personnel with all of the noted precautions, countermeasures and related procedures, and take maximum care when operating this machine.

1.1When using the machine

•Grounding connection

-In order to prevent electric shock at the AC power supply unit, be sure to connect the ground in accordance with operation site regulations (resistance: less than 100 ohms) using the SDP-Eco 1630 III exclusive wire.

-Even when the user's present facility outlet can

be with the SDP-Eco 1630 III power plug with ground, make sure that the ground pole on the outlet is connected with ground in accordance with operation site regulations (resistance: less than 100 ohms)

Following all relevant local wiring regulations, prepare a grounded Warning (less than 100 ohms) power supply outlet that can accept this

machine's power plug.

•Power supply

-Prepare a power supply that satisfies all the requirements stipulated in the specification sheet.

-Always provide circuit breakers for unit or devices that use water or chemicals.

-Please entrust all wiring, connections and other electrical work to an authorized electrician.

•Maintenance and safe passage during emergencies

A minimum of 60 cm clearance is required around the machine at all times to afford adequate space for maintenance and safe passage during emergencies. Never allow this space to become blocked with any objects, wires, or other obstacles.

- 1 -