Mitsubishi Electronics SDP-ECO 1630 III manual Switch the mode between remote and local

SDP-Eco1630 III USERS MANUAL

•Switch the mode between remote and local

Remote Mode Local Mode

Start OK

<Plate Data>

•Shift between commands (Example)

1st hierarchy <Maintenance>

2nd hierarchy Cutter Processor>

•Command execution

<Ver SCSI-ID>

There are two types of commands: one which activates machine functions such as preliminary feeding and cutter-processor commands, and one which is used, for example, to set numerical values.

For commands in which numerical values can be changed (Example: Referring to P27 "4.4 Data input for the set plate")

Use the to move the cursor to the numerical value display. Press the

key to start the display flashing and change the displayed value. (In some modes the numerical value display starts flashing from the time it is first displayed.)

The or key increases/decreases a numerical value.

Press the key when the desired number appears.

If you wish to reset a value or interrupt the setting procedure, press the key to return to the upper menu level without changing the currently set value and re-start the setting procedure from the beginning by selecting the same command.

For commands in which numerical values can not be changed (Example: Referring to P28 "4.5 Execution of Pre. Feed command")

Use the to select the desired command. Then press the key to execute it.

Repeatedly press the key until Start OK is displayed to return to the on- line mode.

- 40 -