Chapter 3 Handling Plates
3.2 Plate end processing
When plate end is displayed, remove the plate and
1)When <Plate End> is displayed on the panel:
The plate ended during exposure, so it is discharged from the processor.
Stop the buzzer by pressing the 
(reset) key.
After the plate is discharged, press the MENU key to shift to the local mode, and mount a new plate following the procedure mentioned in "3.1 Plate setting".
Cover for the plate removal port
Plate removal port
Note | Whether or not data will be |
exposed | depends on | the | ||
amount | of exposure | data | ||
remaining when the plate end | ||||
is detected. |
|
| ||
2) When | Pick up plate | is displayed | ||
on the panel: |
|
|
| |
Plate ended at the beginning of an | ||||
exposure, so the remainder is | ||||
shorter | than | the | processor's | |
minimum transfer length. Please remove the plate.
1.Open the front door and remove the plate through the plate removal port.
2.Close the door and press the 
key to return to the local mode.
3.
- 23 -
