Mitsubishi Electronics SDP-ECO 1630 III Amount using the key or Key and register the value with

Start OK

< Plate Data >

SDP-Eco1630 III USERS MANUAL

4) Inputting the value for the remaining amount of plate (61m to 46m)

M3 F175 414 61m

M3 F175 414 41m

Press the key or the key to move the cursor to the remaining

amount display. Press the key or

the key to start the cursor flashing￿￿￿￿. Change the remaining

amount using the key or the

key and register the value with

the key.

*Press the MENU key to return to the original menu when you finish changing settings.

4.5Execution of Pre. Feed command (This procedure is necessary when loading the plate.)

Close the plate setting cover after the plate roll is set.

(1) Return the menu￿￿￿￿ to the upper level menu using the MENU key.

(2)Select Pre. Feed (preliminary feeding mode) using the key.

Press the key to move to the lower level menu for the preliminary feeding mode. ￿￿￿￿

(3)Use the key to set the plate feeding number to either "1" or "3" -- for "Feed Count 1".

(4)Start preliminary feeding with the key.

Note

- Press the	key after the preliminary feeding. Press the MENU key once to
call up the		display. Press the MENU key once more to call up the
	< Plate Data >

display and switch to the on-line mode.

-Normally, a preliminary feeding must be performed to remove the fogged area after loading a new plate.

- 28 -