Mitsubishi Electronics SDP-ECO 1630 III manual Pre. Feed menu, Image Data menu, Mode menu

SDP-Eco1630 III USERS MANUAL

6.3 Pre. Feed menu

Whenever you set a new plate, a "Pre. Feed" operation is performed to eliminate any fogged sections at the leading edge.

From the display panel, you can select whether to feed 1 or 3 sheets for this operation. The length of each sheet is 500 mm, so if you perform a 3-sheet preliminary feed, 1500 mm of plate will be cut, fed and disposed of.

If there are still darkened or fogged areas on the plate, perform another preliminary feed.

6.4 Image Data menu

The SDP-Eco 1630 III incorporates a hard disk drive buffer to avoid idle time due to differences in calculation speed between itself and the host, and to enable quick re-exposure after an exposure was interrupted (e.g., if you use the stop key or the plate ends).

Data written in the hard disk drive can be exposed or erased in the local mode. Select the "Exposure" command to expose the data and the "Clear" command to erase it.

6.5 Mode menu

In this menu, you can operate the punch (option), select a dryer level, and set the buzzer response for different key operations.

Set the punch to ON to punch plates before image exposure or set it to OFF if punching is not necessary.

If the machine does not contain a punch unit, the "Un-mounted" message appears.

•Punch specifications

Two types of punch unit options can be set: the DS punch (for alternately positionable punch) and the BELL punch.

Note

The distance between punch holes is fixed, so it is impossible to change the distance depending on the plate width.

386.5

Leading side

[DS punch]

φ5

220

5 x 8

Leading side

[BELL punch]

Dedicated for 335mm width plates

12 x 16

10 x 16

Cut line

- 44 -