Chapter 6 User menu
Chapter 6 User menu
It is possible to set values affecting the machine's operation state from the user menu. Note that some settings from the host computer are given priority and they will be automatically changed if the host computer resets them.
Note
Refer to '5.2 Panel operation' for details on key operation.
6.1 Plate data
The < Plate Data >
loaded.
command is used to enter information on the plate to be
Sample panel display
Data | Plate type | Plate width | Remaining |
channel | amount | ||
M 1 | F 1 7 5 | 4 0 4 | 6 0 m |
|
|
|
|
•Data channel
The data channel stores the plate information. 10 different sets of plate parameter data can be stored (from M0 to M9). The plate information consists of plate type, plate width, remaining amount, and the set laser (depends on the resolution for the respective plate type).
•Plate type
You can only use the following three types of plates.
Panel display | Plate model | Remarks | |
|
|
| |
F175 | Polyester base | ||
t 0.175 mm | |||
|
| ||
F100 | Polyester base | ||
t 0.100 mm | |||
|
| ||
R175 | Paper base | ||
t 0.175 mm | |||
|
| ||
|
|
|
•Plate width
Each plate can be set to the following widths (displayed in mm).
- 41 -
