Message | Error contents |
|
|
ME9 | A problem occurred in the heat roller. Please contact the |
| dealer where you purchased this machine. |
|
|
ME10 | A problem occurred when the punch unit was activated. |
| Please contact the dealer where you purchased this |
| machine. |
|
|
ME11 | A problem occurred in the laser adjustment unit. Please |
| contact the dealer where you purchased this machine. |
|
|
Punch | The punch is not mounted. |
|
|
Close front door | The front door is open. Shut the door. |
|
|
Width not enough | The width of the plate is insufficient for the exposure |
| width. Replace the plate with one as wide as the |
| exposure. |
|
|
Image Error | An internal data transmission error occurred in the SDP- |
| Eco 1630 III. |
| If this error occurs frequently, please contact the dealer |
| where you purchased this machine. |
|
|
Plate Set error | The plate has not been set correctly. |
|
|
Plate End | The plate ran out. Load a new plate. |
|
|
Pick up plate | Open the front door and remove a strip type plate |
| through the plate removal port. |
|
|
Waste Tank Check | The waste chemical tank is full. |
|
|
Empty EAC | The EAC chemical ran out. Replenish it. |
|
|
Empty EST | The EST chemical ran out. Replenish it. |
|
|
Tray check | The overflow tray has not been set. Set the tray. |
|
|
I/F error4 | An error has occurred in the SCSI communication. If the |
| error frequently occurs even after the system has been |
| rebooted, contact your local dealer where you purchased |
| this machine. |
|
|
Please set plate | A plate has not been set. Set the plate. |
|
|
SRAM BOARD ERR #1 | A problem occurred in the I/F board. Please contact the |
| dealer where you purchased this machine. |
|
|
SRAM BOARD ERR #2 | A problem occurred in the I/F board. Please contact the |
| dealer where you purchased this machine. |
|
|
SRAM BOARD ERR #3 | A problem occurred in the I/F board. Please contact the |
| dealer where you purchased this machine. |
|
|
NO SUPPORT DIMM | A problem occurred in the memory module for buffer. |
| Please contact the dealer where you purchased this |
| machine. |
|
|
MEM VERIFIY ERR | A problem occurred in the memory module for buffer. |
| Please contact the dealer where you purchased this |
| machine. |
|
|
3.3V REG. ERR NN | A problem occurred in the I/F board. Please contact the |
| dealer where you purchased this machine. |
|
|
- 70 -
