•The alarm function in this machine has been set to OFF before shipment at the factory.
(Settings 000 = OFF)
•The consumption rate of rinse water may be different depending on the settings in the machine. Set the consumption rate with the following procedure.
[Procedure] (In cases where the current values are changed to "150".)
(1) Push the MENU key to display the
< Plate Data >
window.
(2) | Select | < Rinse > |
| with the | key, and then push the | key. | |||||
(3) | When |
|
|
|
|
|
|
|
|
| |
Count 150 CLR |
|
|
|
|
| ||||||
|
|
| is displayed, make sure that the cursor is placed | ||||||||
| under the setting, and then push the |
| key. |
| |||||||
(4) | Push either the |
| key (Increase) or the | key (Decrease) to set the | |||||||
(5) | settings to "150". |
|
| key to confirm the setting. | |||||||
After changing the setting, push the |
| ||||||||||
(6) | Push the MENU key two times to display the |
| window. | ||||||||
< Plate Data > | |||||||||||
Note
Use "120 to 160" as a reference value. Adjust the rate of rinse water reduction depending on the installation conditions of the machine.
(Adjustable range: 50 to 300. Note that using "000" deactivates this function.)
[Notes for adjustment]
(1)When the "Rinse Tank Check" message is displayed. If the replenishing bottle is empty, decrease the setting.
If there is a lot of rinse water left in the bottle, increase the setting.
(2)To deactivate the software counter function, use "000" as a setting value. Be sure to reset the counter by "CLR" after you have adjusted the setting.
- 46 -
