Insert the plate edge until the second buzzer sounds and secure it there.
Turn the nip roller clearance handle back until it is vertical.
Tighten the slack on the plate roll using both hands.
Hold the spool plate to rewind the plate.
Close the plate setting cover.
A buzzer sounds when you start inserting the plate. Insert the plate further until a second buzzer sounds. At the position where the buzzer sounds, turn the nip roller clearance handle back to its vertical position to close the nip.
Caution | Insert the plate edge until |
|
the second buzzer sounds. If you insert it too far (30 mm or more), the plate may jam.
Finally, gently holding the right and left ends of the spool plate rewind the plate to take up any slack. Close the plate setting cover. The plate setting is now completed.
Caution Skewing or meandering may occur during feeding depending on how care- lessly the plate was inserted.
Always insert the plate evenly, holding its left and right edges with both hands.
Follow the procedures "4.4 Data input for the set plate" and
"4.5 Execution of Pre. Feed command" to input data for the set plate. To prepare for the exposure: Remove any section of the plate that has been fogged by friction during preliminary feeding.
- 22 -
