Chapter 5 Menus and panel displays
5.2Panel operation
•Power ON/OFF key
Press this key to turn OFF the power supply to the machine and shut it down (after cleaning the processor roller). To
This key only works in the first local status display and does not work at all in the remote status.
[Final inspection display]
Waste Tank? | Nip Free | Cleaning | Power OFF |
Caution
Final inspection
Always press the Power ON/OFF key when the operation ends.
•Remote mode display
The following display appears on the panel while the remote mode is selected.
START OK
The ON LINE lamp is lit while this is displayed.
Pressing the 
key shows the current state of the plate.
Pressing the 
key shows the number of images in data remaining on the hard disk drive.
Amount of image data which has not yet been exposed.
HDD | 1/2 | Amount of image data in the hard disk drive. |
•Menu/command selection
Use the 
key, 
keys, and 
key to select menus or
commands. The 
key brings up the menu level in the remote and local
modes. The 
keys switch the menu level between remote and local.
The 
keys are used to shift between commands. Selectable commands appear with one of their letters underlined. You can select commands on the right by pressing the right key and commands on the left with the left key.
Pressing the 
key when a ">" mark is shown at the right edge of the menu display shows the next (hidden) menu to the right. (Simply reverse this step to move to hidden menus on the left.) When you find the desired menu, press
the 
key. Proceed to the next menu.
- 39 -
