SDP-Eco1630 III USERS MANUAL

7.2 Cylindrical lens cleaning

 

The SDP-Eco 1630 III incorporates a

 

highly accurate optical system in

Screw

which the lens is positioned

 

extremely close to the exposed

 

surface.

 

Therefore, if the lens is soiled with

 

dirt or dust due to environmental

 

conditions, for example, it may show

 

up as a vertical line (white or black).

 

1)If a vertical line appears, open the

 

front door, loosen the two screws on

 

the cylindrical lens unit, and remove

 

the entire unit by gently pulling it out

 

toward the operator.

Remove the 2)Inspect the lens under a bright

entire unit

fluorescent light to check its

by gently

cleanliness and, if there is any dirt or

pulling it out

toward the

dust, clean it off with a blower.

operator.

 

Cylindrical lens unit

Caution

Do not use compressed air when cleaning the lens.

Cylindrical lens

Clean it off with a blower

3)Never touch the lens with your hand or any kind of tool. These lens can be easily scratched and may require replacement.

Caution The plate will be fogged after you replace the lens. Before the next operation, feed one sheet through the machine.

4)Re-assemble the cylindrical lens unit, reversing the previous procedure. Be sure to firmly re-insert the unit as far back as it will go into the machine chassis.

- 48 -

Page 56
Image 56
Mitsubishi Electronics SDP-ECO 1630 III manual Cylindrical lens cleaning, Dust, clean it off with a blower