7.4 Punch dust removal
When the punch unit (option) is mounted, it is necessary to periodically remove the accumulated punch dust. Too much punch dust may cause trouble. Be sure to remove the punch dust following the steps below.
Caution
If the "Punch Dust Check" warning message is displayed on the operation panel, be sure to remove the punch dust (punching has been performed more than 1000 times).
1)Open the plate setting cover and turn the upper nip roller handle until it is horizontal to rewind the plate. Remove the plate.
Remove the plate
2)Remove the punch box cover at the bottom of the entrance roller where the plate is inserted. The cover is only attached with a magnet, so it can be easily removed by manually pulling on it.
Punch box cover
3)The punch dust is collected in the punch box. Carefully remove the box and discard the dust.
4)
Remove the box
- 50 -
