Mitsubishi Electronics SDP-ECO 1630 III Processor section, Processing chemical replenishment

Chapter 4 Operation

4.7 Processor section

The processing chemicals are applied to the plate while it is being transferred in the SDP-Eco 1630 III's built-in processor section. The processor section also includes a final rinsing process which cleans the developed plates and thus reduces paper media waste (from processing chemical stains) at the start of printing.

Processor rack

Rinse water replenisher bottle

Washing tank
Waste
water hose
SLM-EST
drainage
hose
SLM-EST	SLM-EAC				Cap
replenisher	replenisher
bottle	bottle	SLM-EAC
				Waste chemical tank
SLM-EST	SLM-EAC	drainage
		hose
processing	processing		Waste chemical vat
chemical tank	chemical tank

Caution You must thoroughly read "1.3 Handling processing chemicals".

•Preparing and pouring processing chemical

1)Fasten a replenishment cap on the replenisher bottle which contains the processing chemical and set it in the tank.

Caution

Be sure to set the bottle in the appropriate tank since the SLM-EAC and SLM-EST cause different (opposing) effects.

•Processing chemical replenishment

As the processing chemical decreases, the liquid level in the tank goes down and finally the "Empty EST" or "Empty EAC" message appears on the display (accompanied by a buzzer sound). Replenish the processing chemical following the procedure below.

Replenish the processing chemical and replace the processing bottle following the procedure below.

1)Press the key to turn off the buzzer.

2)Open the front door.

3)Add processing chemical from the container (10 liters) to the replenisher bottle.

4)Put the cap back on the replenisher bottle and set it in the tank.

- 31 -