Mitsubishi Electronics SDP-ECO 1630 III manual Press the Menu Key to display

M3 F175 404 61m

M3 F175 414 61m

Chapter 4 Operation

4.4Data input for the set plate (This procedure is necessary when loading the plate.)

(1)	Press the MENU			key to display the			< Plate Data >	.
(2)	Press the			key to display					, which is a lower
		￿￿￿￿				M0 R 1 7 5 414 00m
	level of the				menu.
			< Plate Data >					￿￿￿￿

(3)Use the ￿￿￿￿key to select the data registration number, plate type, plate

width, or length of plate roll, then press the key to flash the cursor (indicating mode change).

(4)Press the key after changing the data using the or key.

Note • Input the plate data and press the key. Press the MENU key once to call

up the < Plate Data > display and press the key once more to call up the Start OK display and switch to the on-line mode.

(Example)

1) Selection of Data Memory Channel (From M0 to M3)

M0 F175 414 61m

Cursor

M3 F100 404 37m

If setting M3

Press the key in order to start the cursor key flashing and select M0 to

M9 using the key or the

key. Press the key to register the data channel.

2) Selection of plate type (From F100 to F175)
					Press the	key or the		key to
					move the cursor to the F100 display
	M3	F100	404	37m
					(plate type). Press the			key to
					start the cursor flashing.			Select the
	M3	F175	404	61m
					plate type (F175, R175) using the
					key or the		key and press
					the	key to register the plate type.

3) Selection of the plate width (From 404 to 414)

Press the key or the key to move the cursor to the 404 display

(plate width). Press the key to start the cursor flashing. Select the

plate width using the key or the

key and press the key to register the plate width.

- 27 -