DP6T
Figure 3. Deck Fully Raised
To tilt deck up:
Activate switch to lower deck and subsequently move deck into fully tilted position. The actuator will make a ratcheting noise at this position.
To untilt deck:
1.Actuate switch in the opposite direction until actua- tor makes a ratcheting noise and the height gauge indicates 5".
2.Activate switch following instruction decal to lower deck to desired cutting height.
NOTE: Excessive operation of actuator with engine off will drain battery.
NOTE: The micro switch underneath the height gauge prevents the engine from running with the deck in the raised position. The power unit will not move unless the deck is down and the switch lever is depressed. To check that the switch is working properly when the deck is raised, tilt the deck up halfway and move a trac- tion lever out of neutral while sitting in the operator’s seat. This should shut the engine off.
MOWER SIDE-TO-SIDE ADJUSTMENT
(Figure 2 & Figure 4)
Measure a similar spot to the ground on each rear cor- ner of the mower deck. If there is more than an 1/8" dif- ference between sides, adjust lift rods until sides are within 1/8".
MXT Decks
SN
Figure 4. PowerTilt™ Height Adjustment Linkage - MX54T / MX61T
(Rev. 12/22/2007) MAN0253 (Rev. 3/10/2007)
