ASSEMBLY INSTRUCTIONS
DEALER SET-UP INSTRUCTIONS
Assembly of this mower is the responsibility of the Woods dealer. It should be delivered to the owner com- pletely assembled, lubricated, and adjusted for normal cutting conditions.
The mower is shipped partially assembled. Assembly will be easier if components are aligned and loosely assembled before tightening hardware. Recommended torque values for hardware are located on page 47.
DP1
Select a suitable working area. A smooth, hard, level | Figure 15. Left Front Corner Clip & Lag Bolt |
surface, such as concrete, will make assembly much |
|
quicker. |
|
| |
Remove front and rear hardware that secures deck to |
|
crate as shown in Figure 15, Figure 16, and Figure 17. |
|
Remove deck from crate. |
|
Mower Assembly (Figure 18)
1.Remove lock nut (7), flat washer (4), and plastic washer (3) from both carriage bolts on the lift arm.
2.Remove cap screw (6), lock washer (5), and flat
washer (4) from the center hub on the rear pivot lift | DP2 | |
| ||
arm (1). |
| |
Figure 16. Rear Clip & Lag Bolt | ||
3. Attach rear pivot lift arm (1) to the center hub on | ||
| ||
the lift arm and secure with cap screw (6), lock |
| |
| ||
washer (5), and flat washer (4). Torque to 85 |
| |
4. Secure rear pivot lift arm (1) on both sides of center |
| |
hub with lock nuts (7), flat washers (4), and plastic |
| |
washers (3). |
| |
NOTE: Do not overtighten lock nuts (7). Rear pivot |
| |
lift arm must be tight but should pivot with effort. |
| |
5. On MX54 & MX61 models, remove clevis pin (9) |
| |
and safety pin (10) from lift handle. Rotate lift han- | DP3 | |
dle up into the operating position and secure with |
| |
Figure 17. Rear Pivot Lift Arm Lag Bolts | ||
clevis pin (9) and safety pin (10). |
1.Rear pivot lift arm
2.5/8 NC x 2 Carriage bolt GR5
3..53 x 2.0 x .125 Plastic washer
4.5/8 ID x 2.0 OD x 3/8 Thick washer
5.1/2 Lock washer
6.1/2 NC x
7.5/8 NC Lock nut
9..62 x 1.50 Clevis pin
10. .19 x 3.16 Safety pin
Figure 18. Rear Pivot Lift Arm Assembly
22 Assembly | MAN0253 (Rev. 3/10/2007) |
|
|
