WOODS
SAFETY
BATTERY | WARNING | |
Battery acid is caustic and fumes | ||
| ||
are explosive and can cause seri- |
| |
ous injury or death. |
| |
To reduce the risk of personal in- |
| |
jury when working near a battery: |
|
–When working with battery acid, use protective equip- ment such as, but not limited to,
goggles, face shield, rubber gloves and apron.
–Avoid leaning over a battery.
–Do not expose a battery to open flames or sparks.
–Be sure batteries with filler caps are properly filled with fluid.
–Do not allow battery acid to contact eyes or skin. Flush any contacted area with water immediately and get medical help.
–Charge batteries in an open, well ventilated area, away from sparks and flames. Unplug charger before connecting or disconnecting from bat- tery.
STORAGE SAFETY
–Stop the engine and allow to cool before storing.
–Drain the fuel tank outdoors only.
–Store fuel in an approved container in a cool, dry place.
–Keep the machine and fuel containers in a locked storage place to prevent tampering and to keep children from playing with them.
–When the machine is to be parked, stored or left unattended, lower the cutterdeck unless a posi- tive mechanical lock is used.
–Do not store the machine or fuel container near heating appliances with an open flame such as a water heater or an appliance with a pilot light.
–Keep gasoline storage area free of grass, leaves and excessive grease to reduce fire hazard.
JUMP STARTING
1.Be sure the jumper cables are in good condition. Turn off the ignition and all electrical accessories on both machines.
2.Position the machine with a good (charged) bat- tery next to but not touching the machine with the dead battery so jumper cables will reach.
3.When making cable connections:
-make sure the clamps do not touch anywhere except to intended metal parts,
-Never connect a positive ("+" or red) terminal to a negative
-Make sure the cables won't get caught in any parts after the engines are started.
4.Connect one end of the first jumper cable to the positive terminal on one battery. Connect the other end to the positive terminal on the other battery.
5.Connect one end of the other cable to the negative terminal of the machine with a good
(charged) battery. Make the final connection on the engine of the machine to be started, away from the battery.
6.Start the vehicle with the good battery, then the machine with the discharged battery.
7.Remove the cables in the exact reverse order of installation. When removing each clamp, take care it does not touch any other metal parts while the other end remains attached.
11
