Pushing the Machine | Woods Equipment MZ2252K manual

CONTROLS

WOODS

PARKING BRAKE (R) - Pull the parking brake lever up and back to put the parking brake ON. Push it forward and down to put the parking brake OFF.

The parking brake must be ON to start the engine. It must also be ON to keep the engine running if the operator leaves the seat. The parking brake must be OFF to keep the engine running when a traction lever is moved out of neutral lock.

Parking brake in ON position

(operator's left side)

PUSHING THE MACHINE

Hydrostat bypass valves (“dump valves”) on each hydrostatic pump allow the machine to be pushed or towed without the engine running. Raise the seat to gain access to these two valves V. Turn both valves counterclockwise 1 turn to release the hydrostatic system. Restore the hydrostatic system by turning the valves clockwise only until they re-seat. DO NOT overtighten.

Use caution if it is necessary to tow the machine. With the bypass valves open, the dynamic braking and steering provided by the hydrostats is disabled. Towing should be done only if a disabled machine cannot be repaired where it broke down.

Compartment beneath the seat,

viewed from above

20

Image 20

Woods Equipment MZ2252K manual Pushing the Machine, Parking brake in on position Operators left side

Contents

OPERATOR’S Manual California Wash Hands After Handling Important Message To the DealerTo the Owner Alitec BMP Central Fabricators Gannon Gill WAIN-ROY Woods Table of Contents Safety Become Alert Preparing for Safe Operation Starting Machine Operation Operating SafelyGeneral Interrupting operation Maneuvering Safely Mowing Slopes Seat Belt Useage Maintenance Safety General BladesFuel Hydraulic System Jump Starting BatteryStorage Safety Labels OFF LH Tank RH Tank Operators Manual is Located Under the Foot Plate Hydraulic OIL TRANSPORT5 NN N Controls At operators right side Turns during reverse movement Lift and traction levers operators right sideTurns during forward movement Foot Lift Pedal Compartment beneath the seat Viewed from above Pushing the MachineParking brake in on position Operators left side PRE-OPERATION Check List PRE-OPERATION Check List OWNER’S Responsibility Operation FuelingBefore Starting the Engine Operator Presence Interlock System Operating Notes Driving Cutting Cutting Tips Maintenance Chart EngineHydraulics Machine Maintenance Record General Check Daily MaintenanceBattery Lubrication Periodic OIL Changes Hydraulic SystemAfter First Five 5 Hours Fuel Filter Engine OILSpark Plugs Engine Cooling Heavy Duty Cyclonic AIR CleanerTo replace air cleaner elements Cleaning Machine Washing Machine Blade Installation Blade RemovalSharpening Blade Balance Counterbalance Springs AdjustmentsDeck Leveling Height of cut ranges for roller adjustment Height of CUTRear Deck Rollers Front Deck LIP Parking brake assembly tire and deck not shown Control LeversParking Brake For clarity brake in on position Hydrostat Adjustments Right side adjustmentsNeutral Reverse Return Dampers Cutterdeck BeltTracking Handles Belt Replacement PUMP-DRIVE Belt Limited Warranty 8495 MM & Boundary Repair Parts Rev /15/2006 Woods Equipment Company