
ADJUSTMENTS
WOODS
CUTTERDECK BELT
1.Tilt floorplate all the way forward.
2.Set the cutterdeck in a middle
3.Use a 3/8" ratchet and extension to back tensioning idler off to remove belt from idler. Remove belt from cutterdeck pulleys.
NOTE: Use the 3/8" ratchet in the square hole A on the idler.
4.Remove belt from clutch pulley.
5.Install the new belt by performing these steps in reverse order.
Note: Always use Woods replacement belts, not general purpose belts. Woods belts are specially designed for use on commercial mowers and will normally last longer.
TRACKING HANDLES
An adjustment is provided to allow the operator to align the control levers with each other during opera- tion.
1.Turn knob W clockwise to shorten control lever travel.
2.Turn knob W
DAMPERS
Different damper mounting holes have been provided for various operator preferences with control lever motion.
1.For a stronger resistance feel, mount the damp- ers X in the outer most hole Z of the motion control weldment.
2.For a lighter resistance feel, mount the dampers X in the inner most hole V of the motion control weldment.
38