WOODS
ADJUSTMENTS
HEIGHT OF CUT
The height of cut is set by moving height of cut pin C to the hole designated for the height of cut desired.
To change the height of cut:
1.Lift the deck to the highest position.
2.Move pin C to the selected hole.
3.Lower the deck until the lift lever is stopped by the pin.
NOTES:
–Height of cut may vary due to the amount of tread on the tires, tire diameter or inflation pres- sure.
–For best results, adjust the rear deck rollers for the height of cut to be used (see below).
REAR DECK ROLLERS
The rear outside deck rollers are adjustable up and down to provide improved deck flotation and scalp- ing protection at various heights of cut. They are not intended to ride continuously on the ground. Adjust no closer than 3/8" (10mm) to the ground.
Height of cut ranges for roller adjustment
FRONT DECK LIP
Adjustable front deck lips have been provided on 52 in. and 61 in. cutterdecks for various cutting condi- tions.
To revise per conditions:
1.Loosen the front bolts S.
2.Adjust height of H.
3.Retighten S once you have desired height.
35
