Set Up, Unpacking, Inventory, Lifting Hazard | Woodstock W1701

W1701 1HP Shaper

SET UP

Unpacking

The SHOP FOX® Model W1701 has been carefully pack- aged for safe transporting. If you notice the machine has been damaged, please contact your authorized SHOP FOX® dealer immediately.

If any parts are missing, examine the pack- aging for the missing parts. For any missing parts, find the part number in the back of this manual and contact Woodstock International, Inc. at (360) 734-3482 or at tech-support@shopfox.biz

Inventory

The following is a description of the main components shipped with the SHOP FOX® Model W1701. Lay the components out to inventory them.

Note: Some parts and hardware may already be installed on the machine. make sure to check the machine when you use the inventory list.

LIFTING HAZARD!

Get help lifting and mov- ing the heavy components of this shaper.

SET UP

D

A

E

G

J

B

F

H

C

I

K

L

M

O

N

P

Figure 8. Component layout.

-8-

Image 11

Woodstock W1701 owner manual Set Up, Unpacking, Inventory, Lifting Hazard

Contents

Copyright FEBRUARY, 2008 by Woodstock INTERNATIONAL, INC Model W1701PART# Description HP Shaper Page Contents Woodstock Technical Support SpecificationsIntroduction Standard Safety Instructions Safety Always Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Shapers Use a Shop FOX Featherboard as Anti-kick back protection Avoiding Potential Injuries Grounding Electrical110V Operation Extension Cords Lifting Hazard SET UPUnpacking Inventory Inventory List Machine PlacementCleaning Machine Main Contents Qty Laceration Hazard Assembly Test Run Cutters vs. Router Bits OperationsGeneral Cutter Contact Hazard Spindle ElevationSpindle Direction To set the spindle height, do these steps Table Inserts Fence PositioningFence Alignment Cutter FLY-APART Hazard Cutter InstallationThere are three set up positions for rub collars Accidental START-UP Hazard AMPUTATION/LACERATION Hazard To install cutters and rub collars, do these steps To install the router bit collet, do these steps Router Bit Installation Straight Shaping To set up the fence for partial edge removal, do these steps Template Construction Tips Templates Starting pin operation Guard not shown for clarity Freehand Shaping Lubrication MaintenanceMaintenance Schedule Table & Base Loosen the belt adjustment bolts as shown in Figure ServiceBelt Adjustment To adjust belt, do these steps Table Spacer Kit To install the table spacer kit, do these steps To replace the spindle cartridge assembly Spindle Cartridge Replacement Resurfacing a shaper fence on a Jointer ON/OFF Switch Motor & FWD/REV Switch Electrical Components & Wiring Parts PART# Description Parts List Cutterspindle Warranty Comments Warranty Registration BOX BELLINGHAM, WA Woodstock International INC